-
Materials and instructions for replacing overvoltage relay and starter power relay in the PA-18 electrical system.
-
Operational and maintenance procedures used to reduce or maintain lead deposits at a minimum when using higher lead content aviation fuel more than 25% of engine operating time.
-
Information on how to improve the lubrication characteristics of the Bendix S-1200 series magnetos.
-
Failure of part number 69650 piston pins, caused by transverse grinding or heat cracks which occurred during manufacture of the piston pin.
-
Instructions for replacing the old style Piper Automatic Location Transmitters with newer models.
-
General guidelines for inspection and maintenance of control surfaces.
-
Contains the Ceconite Application, Maintenance and Repair Procedures for Piper PA-18 and PA-25 models.
-
The following listing denotes the location of the Cylinder Head Temperature Probe for Piper aircraft.
-
Installation of Muffler Support Kit No. 756-803, and Tailpipe Support Kit No. 756-804, will be instrumental in extending the service life of the exhaust system.
-
At each 100 hour inspection, the bushing, washer and nut of the stabilizer yoke assembly should be inspected for wear and, if worn, should be replaced.