Popular Articles

  1. AD 47-43-04 Rudder Control Cable Horns

    Remove the forward part of the tunnel fairing on the cockpit floor and inspect the control cable horns on the rudder bar for signs of bending.
  2. SB-02 Piper Special Tubing in Fuselage

    Replacing fuselage tubes beneath the seats and floorboards due to damage.
  3. SB-88 Piper J-3 Scott Master Cylinder Relocation

    Instructions for moving the Scott Brake cylinders from a position directly aft of the rear rudder pedals to a new position as shown in the attached sketches.
  4. SM-54 Ercoupe Installation of the Trim-O-Matic

    Instructions for the installation of the Trim-O-Matic (T-O-M).
  5. Stinson Control Surface Balance Weight Information

    Stinson control surface balance weight information.
  6. AD 76-06-06 Loss of Flap Control

    Inspect the flap control system to ensure that six flap control pulley guards are properly installed.
  7. EB-13 Luscombe Baffle Modifications

    Arranging baffling for better engine cooling.
  8. SB-182 Piper Control Cable Replacement on Foreign Registered Airplanes

    Inspection of control cables and replacement of 1/8” 7 x 19 flexible stainless steel control cables on foreign registered airplanes.
  9. AD 47-20-08 Battery Box Drain

    Install a new battery box drain tube to extend at least 1/2 inch below the fuselage belly skin if this has not been already incorporated in the airplane.
  10. SB-102 Piper PA-12 Electrical System

    Summary of service difficulties experienced with the electrical system in the Model PA-12 and recommendations as to how to remedy these difficulties.