-
The longitudinal trim system for the Ercoupe has been redesigned to employ a movable section on the trailing edge of the elevator.
-
At each 100 hour inspection, the bushing, washer and nut of the stabilizer yoke assembly should be inspected for wear and, if worn, should be replaced.
-
Outlines the repair of Univair STC'd Stamped Ribs in accordance with the original STC and FAA Advisory Circular AC 43.13-1B.
-
Incorporating a heavy duty navigation light switch, Piper part number 484-575, manufactured by the Ohmite Manufacturing Company.
-
Last Updated: 10/08/2021
in Technical Information Ercoupe
List of attaching hardware for Ercoupe front and rear beams.
-
Last Updated: 10/08/2021
in Technical Information Ercoupe
Instructions and drawing for Service Kit 48.
-
Specifications and performance data for Piper PA-18 with Continental 90hp and Lycoming 108hp engines.
-
Information from the Piper J-3 Parts Manual on aileron pulley installation in pre-war Piper J-3.
-
Safety measure to prevent possible icing of the lower end of the crankcase breather tube.
-
Possibility of the flap cables on the PA-18A becoming fouled between the hopper and the diagonal fuselage tube.