Popular Articles

  1. AD 46-36-03 Muffler Brace

    Install additional brace tube to prevent possible failure of the tailpipe and cracking of the muffler.
  2. AD 47-47-02 Battery Box Insulating Spacer

    Installing a wood filler block to eliminate the possibility of a short circuit occurring between the battery terminal bases and the battery box.
  3. SB-257 Stinson Elevator Trim Tab Horn

    The following repair procedure is recommended for those aircraft on which the hole in the elevator tab control horn has elongated.
  4. SB-260 Stinson Misalignment of Two Forward Rudder Cable Pulleys

    Inspection procedure for determining if rudder cables have frayed due to misalignment of the pulley brackets located on the fuselage structure.
  5. SB P-1 Univair Throttle Inspection in Piper Airplanes

    Steps to preclude failure of the U12694 series throttle cables, which could cause loss of full travel of the throttle control.
  6. SB-50 Piper J-2 thru J-5 Ribstitching

    Reported failures of the ribstitching both in the wing and control surface covering which may result in the fabric being torn from the structure while in flight.
  7. AD 47-43-03 Seaplane Spreader Struts

    Due to the independent suspension of the floats, racking loads imposed by rough water operation can cause extensive structural damage. As a result, the following inspections and modifications are necessary.
  8. SL-195 Piper PA-18A Battery Cable and Rudder Cable Interference

    Procedure for correcting the installation of the battery cable to prevent interference with the left rudder cable on the PA-18A agricultural airplane.
  9. SB-53 Piper J-3/J-5 Fuel Shut-Off Swivel Fitting

    Failure of the fuel shut-off control attachment at the swivel fitting.
  10. SB-522 Piper Wing Fuel Tank Cap Modification

    Reports of collapsed wing mounted fuel tanks due to inadequate venting of the tank.